Hi
In trying to create an emulator of a Samsung tablet (Tab A 9.7 for example), I start with “New Hardware Profile” which goes to “Choose a device definition”
I’m not sure if it’s suppose to, but the Galaxy_Tab_A_9.7 does not show up, so I chose the Nexus 10.
As you can see, that is not a good selection (not big enough)
So if I go back to the “Choose a device definition” and click “Next”, on the next screen (Configure Hardware Profile small.png -- see attached) which is
“Select a system image” (attached image), there is nothing there to select from
Images referenced above are attached, I couldn't figure out how to insert them into the message flow.
I’m using Studio 4.0.
Any idea of what I’m doing wrong would be greatly appreciated.
Thanks…
In trying to create an emulator of a Samsung tablet (Tab A 9.7 for example), I start with “New Hardware Profile” which goes to “Choose a device definition”
I’m not sure if it’s suppose to, but the Galaxy_Tab_A_9.7 does not show up, so I chose the Nexus 10.
As you can see, that is not a good selection (not big enough)
So if I go back to the “Choose a device definition” and click “Next”, on the next screen (Configure Hardware Profile small.png -- see attached) which is
“Select a system image” (attached image), there is nothing there to select from
Images referenced above are attached, I couldn't figure out how to insert them into the message flow.
I’m using Studio 4.0.
Any idea of what I’m doing wrong would be greatly appreciated.
Thanks…
