Galaxy Tab A10.1 2019 brick issue

[schnaps991]

Hello everyone. Im in a bit of a pickle with my Tab. The invalid kernel length message appeared along with an annoying boot loop and i tried flashing it so i booted it into download mode. Midway i realised i had the wrong firmware downloaded so i booted out of it using lock&vol down and then when i tried to boot back into it there's no warnings or "downloading" screen, just the plain download mode information on the top left and the device seems completely unresponsive. anyone had this happen before?

 

[ocnbrze]

well..... you never disrupt an install. you most likely screwed your system partition by doing so. so now the install is incomplete. i think you bricked it. not much you can do, but to get you new device......sorry

 

[ocnbrze]

or the other option is to take it to a repair shop. maybe you can get it fixed for cheap.

 

[schnaps991]

well..... you never disrupt an install. you most likely screwed your system partition by doing so. so now the install is incomplete. i think you bricked it. not much you can do, but to get you new device......sorry

i hadn't started odin though,i was in the point of loading the md5s until i saw that there was a CP md5 which is not possible since my tab is the wi-fi version so technically there was no install going on when i booted out of it

 

[schnaps991]

i hadn't started odin though,i was in the point of loading the md5s until i saw that there was a CP md5 which is not possible since my tab is the wi-fi version so technically there was no install going on when i booted out of it

This is how it looks booting into download mode now