Long story short. I was .340 rooted with apex 1.4.1. About a week ago I started getting a nagging upgrade message to .605 every 12 hours. I finally decided to sit down today and upgrade to .605 and apex 2.0
Now im screwed. I SBFed back to stock .340 and took the OTA to .605. Then when I tried to flash APEX it just got locked in the APEX start screen. And when I say locked, I mean a waited like 15 min.
So I decided to start over again. Tried to SBF back to .340 and shit just wont do anything now. When I tried to SBF back it just went through the process and locked up after reboot.
Figured going from .605 to .340 was the problem so I tried to SBF to .602 same problem. Tried to do a factory reset by holding the home and power button but it just comes up with a triangle with a ! and stops.
Where am I going wrong?
Now im screwed. I SBFed back to stock .340 and took the OTA to .605. Then when I tried to flash APEX it just got locked in the APEX start screen. And when I say locked, I mean a waited like 15 min.
So I decided to start over again. Tried to SBF back to .340 and shit just wont do anything now. When I tried to SBF back it just went through the process and locked up after reboot.
Figured going from .605 to .340 was the problem so I tried to SBF to .602 same problem. Tried to do a factory reset by holding the home and power button but it just comes up with a triangle with a ! and stops.
Where am I going wrong?