Root Missing High Sensitivity Mode - CM12.1 UNOFFICIAL - HELP

[st90ar]

A few days ago, I flashed the CM12.1 ROM. Everything was fine, up until I mistyped something in the build.prop. Also, I didn't completely wipe my phone as I should have from the beginning, so there was a bunch of lingering files from the old stock installation. So this time, I wiped it completely clean and installed CM12.1 Unofficial. Everything is fine and dandy, and it's working quite well. Only major issue is the sensitivity of the screen. Before I completely wiped and reflashed, I remember seeing a High Sensitivity Mode (or Glove Mode) in one of the menus as I was browsing available options. However, after reflashing, it's nowhere to be found. So I am left with one of two questions...

1. Is there a way to bring back the "Glove Mode" settings? and

2. Is there a way to adjust the value of the screen sensitivity so it's not so sensitive? (A smudge from my fingers on the screen can render it useless until I turn the screen off and clean it. Which gets tiresome after 40-50 times.)

Thanks!

 

[dvdavid888]

I have the same problem

 

[st90ar]

Any help? I've gone through the build.prop, and the LGE touchscreen settings, and can't seem to find anything. I did find a value to manually set the physical input size of the thumb input, but am not sure what the proper value should be set to. Often, my screen is useless as I have to wait until I get home to clean the screen of finger oil so the screen becomes usable again. It's seriously too sensitive, and I can't find a way to bring back the High Sensitivity Mode option into CM12.1.