Ok, I repartitioned the card and ran a2sd check...all looks good. According to the output from a2sd check, I need to type a2sd cachesd to run the dalvik cache on the sd card. I did this and it caused the phone to reboot (although before it did I saw an error message in Terminal Emulator...something about a "broken pipe"). I ran a2sd check again once it finished rebooting and it looks like the change took, though...dalvik is now running on SD. I then typed a2sd zipalign...I got the same error in the readout right after the Launching Apps2SD line ("cat: write error: Broken pipe"...whatever that means!). But it looks like it worked as well...I see "Starting DarkTremor Apps2SD in zipalign mode". So, if the "broken pipe" error isn't critical, I'm ok with it.
The most important thing is: I now have 217mb free of internal memory (woo hoo!), which was really the whole point of this whole exercise, so it looks like I was successful. My last question: when I ran the old Apps2SD app just to check, it says there are still a couple of apps that can be moved to external storage. I didn't do anything with them, but should I? Or can I just remove apps2SD app completely now, because it's really not doing anything? Thanks again for the help...I definitely can see the light at the end of the tunnel!
The most important thing is: I now have 217mb free of internal memory (woo hoo!), which was really the whole point of this whole exercise, so it looks like I was successful. My last question: when I ran the old Apps2SD app just to check, it says there are still a couple of apps that can be moved to external storage. I didn't do anything with them, but should I? Or can I just remove apps2SD app completely now, because it's really not doing anything? Thanks again for the help...I definitely can see the light at the end of the tunnel!