nyssa
Well-Known Member
If I wanted to JUST root and not flash anything (for now), and I wanted to use CWM as my recovery, what would the process look like? Something like this?
1: download HTC Sync / mini-sdk; install.
2: open CMD / navigate to sdk.
3: turn off fastboot / turn on debugging
4: plug in phone / go into bootloader / flash unlock code
This is where I get stuck; I'm not using an img for my recovery, I was planning on doing it through the CWM app. So would I just reboot at this point, install the app, then install CWM recovery and backup as usual?
1: download HTC Sync / mini-sdk; install.
2: open CMD / navigate to sdk.
3: turn off fastboot / turn on debugging
4: plug in phone / go into bootloader / flash unlock code
This is where I get stuck; I'm not using an img for my recovery, I was planning on doing it through the CWM app. So would I just reboot at this point, install the app, then install CWM recovery and backup as usual?


I should be good now.
I only want to root the phone. I want the phone stock with VM and HTC software, only with root access. No rom or kernal, if possible. So where in that guide does the rooting process actually take place and finish? A ctrl-f of the op only turns up 4 instances of the term "root". None of which say that basically say "Ok, in this step you are going to root your device blah blah blah"